Sale

(6 PACK) Rust-Oleum Reflective Finish - 283g Spray

ABOUT REFLECTIVE FINISH SPRAY

Rust-Oleum® Specialty Reflective Finish Spray illuminates painted surfaces under direct headlights for nighttime visibility and safety. Apply to metal, wood, plastic, concrete or masonry.

  • Great for mailboxes, gates and trash cans
  • Indoor/ Outdoor
  • Semi-transparent finish

FOR BEST RESULTS

Shake can approximately 4 seconds for every 15 seconds of use. Do not apply heavy coats that look wet. Effect works best with light coats.

AVAILABLE SIZES

  • 283 g Spray per can
  • 6 cans per order

 

DESCRIPTION AND USES 

Rust-Oleum® Specialty Reflective Spray is a semitransparent finish that reflects light for nighttime visibility and safety. Surfaces painted with Reflective Finish appear bright when headlights illuminate it. Ideal for use on mailboxes, gates, trash cans, light posts, bicycles, driveway rocks and more. .

PAINTING CONDITIONS

Use outdoors or in a well ventilated area. Use when temperature is between 50-90°F (10-32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Do not apply to galvanized steel. Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist. 

PRODUCT APPLICATION

SURFACE PREPARATION

Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Removal of old paint by sanding, scraping or other means may generate dust or fumes that contain lead.

APPLICATION

Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle

DO NOT STRIKE CAN.

IMPORTANT! Shake can approximately 4 seconds for every 15 seconds of use. Hold can upright 10-16” from surface and spray in a steady backand-forth motion, slightly overlapping each stroke. Keep the can in motion while spraying. Keep the can the same distance from the surface. Apply 2-3 light coats 1-2 minutes apart. DO NOT APPLY HEAVY COATS THAT LOOK WET. The effect works best when light coats are applied. Do not use near open flame.

DRY & RECOAT

Dry and recoat times are based on 70ºF (21°C) and 50% relative humidity. Allow more time at cooler temperatures. The finish dries to the touch in 1-3 hours. Allow 5-9 hours to handle and 24 hours to fully dry. CLEAN-UP Clean valve immediately after use by turning can upside down and depressing the spray button for 3-5 seconds (some paint will be sprayed out, so be careful to not inadvertently spray yourself or other objects). Clean up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.

CLOGGING If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening