(6 PACK) - Rustoleum Adhesion Promoter 251572

3 items left

ABOUT ADHESION PROMOTER - 6 PACK

Rust-Oleum Adhesion Promoter is a fast drying, clear primer that helps paints adhere to polyolefin surfaces such as automotive plastics, vinyl, trim, bumpers, fiberglass and more.

  • Bonds topcoats to vinyl, plastic, fiberglass and more
  • Adhesion Promoter features an advanced spray system that allows you to spray at any angle
  • A comfort spray tip with wider finger pad
  • Item Number 251572

FOR BEST RESULTS

A top coat must be applied within 10 minutes of the final coat of Adhesion Promoter.

AVAILABLE SIZES

  • 320 grams per can
  • 6 Cans per order

PAINTING CONDITIONS Use outdoors or in a well ventilated area such as an open garage. Use when temperature is between 50°F and 90°F (10- 32°C) and humidity is below 85% to ensure proper drying. Do not apply to surfaces, when heated, exceed 200°F (93°C). Avoid spraying in very windy and dusty conditions. Cover surrounding area to protect from spray mist.

SURFACE PREPARATION Remove all dirt, grease, oil, salt and chemical contaminants by washing the surface with a commercial detergent, or other suitable cleaning method. Rinse with fresh water and allow to thoroughly dry. Clean area to be primed with mineral spirits to remove all oil, grease, wax, and dirt. Remove loose paint with a wire brush or sandpaper. Lightly sand glossy surfaces. Wipe the sanded surface clean when finished.

APPLICATION Shake can vigorously for one minute after the mixing ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often during use. Hold can 12-16" from the surface and spray in a steady back-and-forth motion, slightly overlapping each stroke. Keep the can the same distance from the surface. Keep the can in motion while spraying. For best results, apply 2 or more light coats a few minutes apart. Do not use near open flame.

DRY & RECOAT Dry and recoat times are based on 70°F and 50% relative humidity. Allow more time at cooler temperatures. Dries to touch in 10 minutes and dries to handle in 15-30 minutes. A topcoat must be applied within 10 minutes after primer application. For best results apply a finish coat of Rust-Oleum Automotive finish.

CLEAN-UP Wipe off tip when finished. Clean-up wet paint with xylene or mineral spirits. Properly discard empty container. Do not burn or place in home trash compactor.

CLOGGING If the valve clogs, twist and pull off spray tip and rinse in a solvent such as mineral spirits. Do not insert any object into can valve opening.